spacer block การใช้

• Place spacer blocks under the rail if you need to raise it higher.
• Spacer blocks provide extra insulation by filling dead wall space.
• Now drill pilot holes for the spike and ferrule fasteners, keeping spacer blocks in place.
• NOTE : Drawing captioned " USING A SPACER BLOCK BETWEEN STUDS " goes with this column.
• Before replacing the molding, insert wooden spacer blocks in the cavities above and below the wedges.
• Use short lengths of 2-by-4's to make spacer blocks, and insert them between the plywood forms.
• Use a spacer block to keep the gutter from bending while you cut it with a hacksaw.
• Place the bottom stringer so each end rests on a spacer block, then nail it to the post.
• Cut two more spacer blocks 38 inches long and place them at posts so they rest on the bottom stringers.
• In some ships the gap between the lower uneven futtock and the lapstrake planks was filled with a spacer block about long.
• CAPTION : A 2x4 spacer block placed flat against floor plate will keep stud from shifting while it is being toenailed in place.
• The third stud is lined up with but separated from the last stud in the corner by spacer blocks affixed to the last stud.
• Spacer blocks were added to the front and back of the feedway to guide the shorter round and block the use of the longer . 30-06 Springfield ammunition.
• You can enlist the aid of a strong-armed helper to hold each stringer as you nail it in place, or if you are working alone, you can use spacer blocks to support the stringers as you toenail.
• A : Cut a short length of 2x4 to act as a " spacer block, " cutting it to the exact length of the space needed between the studs ( in your case 14 1 / 2 inches ).
• After each vertical stud has been nailed in position, place this spacer block flat against the 2x4 floor plate with its end against that stud, then position the bottom of the next stud against the other end of the spacer block.
• After each vertical stud has been nailed in position, place this spacer block flat against the 2x4 floor plate with its end against that stud, then position the bottom of the next stud against the other end of the spacer block.
• Shearleg derrick is similar to breast with an exception that instead of fixed guy wires that secure the top of the mast, it is secured by multiple reeved guy to permit handling loads at various radii by means of lashing but with a small spacer block placed between the legs.